Contents11

Only use a heater in a bathroom if its manual or the maker’s page says it’s made for bathroom use. If it doesn’t say so, don’t use it there.

Even with a heater made for bathroom use, the outlet and the placement matter. The checks below cover both.

What to check before you plug it in

Each situation has its own check. Find the one that matches your bathroom.

Situation What to check
Heater inside the bathroom The manual or the maker’s page says it’s made for bathroom use
Outlet in the bathroom It should be GFCI-protected
Anything flammable nearby Keep 3 ft of clear space around it
Heater knocked over Check the manual for tip-over shutoff before you buy

Bathroom heater check

Say whether your bathroom outlet is GFCI-protected and how long you run the heater each time. It shows what to check, the energy per use, and the pick made for bathroom use.

The table pulls together the makers’ pages and the CPSC and NFPA guidance used in this guide.

What the makers say about bathrooms

Per Lasko’s and Vornado’s support pages, Lasko recommends that its conventional space heaters not be used in wet or damp locations, including bathrooms. Vornado says its heaters aren’t intended for bathrooms.

A “bathroom” label that appears only on a store listing isn’t the same as the maker saying it. Look for the claim in the manual or on the maker’s own page.

Size, power and what a small heater gives you

Per Lasko’s product page, this guide’s pick is designed for bathroom use and lists an integrated ALCI safety plug and overheat protection. It runs from 900 W to 1,500 W at 120 V with a 6-foot cord, and has no adjustable thermostat. It stands 8 in tall on a 6.25 × 6.25 in footprint and weighs 3.35 lb.

This guide found no official explanation of how the ALCI plug works. It also has no official heating-area figure for the pick, so it doesn’t say how many square feet it warms.

Tip-over shutoff and basic safety

This guide couldn’t confirm a tip-over shutoff on the pick’s official product page, so check the manual before you buy.

According to the CPSC and NFPA, plug a space heater straight into a wall outlet, never an extension cord or power strip. Keep it at least 3 feet from anything that can burn. NFPA also says to look for one that shuts off if it tips over.

Floor space is tight in a bathroom, so place the heater where nobody will kick it or step over the cord.

Outlet, cord and energy use

Per IAEI’s explanation of the National Electrical Code, the code calls for GFCI protection on receptacles in home bathrooms. Check whether your own bathroom outlet is GFCI-protected.

The pick’s cord is 6 ft long. Measure the distance from the outlet to where the heater will sit, and don’t add an extension cord.

Assuming 15 minutes per use, a 1,500 W heater uses about 0.375 kWh; 10 to 30 minutes is 0.25 to 0.75 kWh. The 15-minute figure is an assumption, so scale it to how long you actually run it.

A pick for a bathroom

On Amazon.com on November 5, 2026, one heater met both rules: an official bathroom-use claim and an eligible listing. Listings that say ‘bathroom’ only on Amazon, not on the maker’s own page, weren’t picked.

Picks are new, with 100+ ratings and 4.0+ stars, sold by Amazon.com or the brand. The cheapest one that meets that pick’s condition is the pick.

  • For a heater made for bathroom use, the pick is Lasko CD08200. On Amazon.com on November 5, 2026, it’s sold by Amazon.com with a matching model number. Lasko’s product page says it’s designed for bathroom use, but this guide found no tip-over shutoff listed there, so check the manual before you buy.

Check the price on Amazon.com.

FAQ

Can I use a space heater in a bathroom?

Only use a heater in a bathroom if its manual or the maker’s page says it’s made for bathroom use. If it doesn’t say so, don’t use it there.

Is a GFCI outlet enough to use any space heater in a bathroom?

Per IAEI’s explanation of the National Electrical Code, the code calls for GFCI protection on receptacles in home bathrooms. That covers the outlet only.

Check the manual or the maker’s page for the heater itself.

Can I put a space heater in a half bath?

A half bath is still a bathroom, so the same rule applies. Use only a heater whose manual or maker’s page says it’s made for bathroom use.

What small heater is OK for a bathroom?

Pick a small heater whose maker’s page says it’s made for bathroom use, and check the manual for tip-over shutoff. Per Lasko’s product page, this guide’s pick is designed for bathroom use and lists an integrated ALCI safety plug and overheat protection.

It runs from 900 W to 1,500 W at 120 V with a 6-foot cord, and has no adjustable thermostat. It stands 8 in tall on a 6.25 × 6.25 in footprint and weighs 3.35 lb.

Data and formulas used (for verification)

Related guides:

How this was checked: As of November 2026, this guide reads the makers’ U.S. support and product pages, IAEI’s explanation of the National Electrical Code, and CPSC and NFPA guidance. Nothing was tested by hand, and the sources and the figures behind each pick are in the data section at the end of the page.

Method

  • Covers Lasko’s and Vornado’s U.S. support pages, Lasko’s U.S. product page for the pick, IAEI’s explanation of NEC 210.8, and CPSC and NFPA space-heater guidance, plus Amazon.com listings, all checked November 5, 2026. No heater was tested hands-on.
  • Bathroom use, plug, overheat protection, wattage, size, weight and cord length come from Lasko’s official page. A listing that says ‘bathroom’ only on Amazon isn’t treated as the maker’s claim.
  • Use time is assumed at 15 minutes, with 10 to 30 minutes as the range. Energy (kWh) = watts × minutes ÷ 60 ÷ 1000.

The pick’s official specs (Lasko CD08200, Lasko’s U.S. page)

Item Official Source
Bathroom use Designed specifically for bathroom use lasko.com
Plug Integrated ALCI safety plug lasko.com
Overheat protection Yes lasko.com
Tip-over shutoff Not confirmed on the official page lasko.com
Wattage 900 W to 1,500 W, 120 V lasko.com
Thermostat No adjustable thermostat lasko.com
Timer One button for one hour of high heat lasko.com
Size 8 × 6.25 × 6.25 in (H × D × W) lasko.com
Weight 3.35 lb lasko.com
Cord 6 ft lasko.com
  • Bathroom rule: Lasko’s support page recommends its conventional space heaters not be used in wet or damp locations, including bathrooms; Vornado’s FAQ says its heaters aren’t intended for bathrooms. These are each maker’s statements about its own heaters.
  • GFCI: IAEI’s explanation of NEC 210.8(A)(1) says 125-volt, 15- and 20-amp receptacles in dwelling-unit bathrooms must be GFCI protected. Whether a given home’s outlet has it wasn’t checked.
  • ALCI: listed as a feature on Lasko’s page. This guide didn’t find an official explanation of how an ALCI plug works.
  • Energy: 1,500 W for 15 minutes is 0.375 kWh, about 6.8 cents at the U.S. average of 18.16 cents/kWh (EIA, August 2026). 30 uses a month is 11.25 kWh, about $2.04. Your utility’s rate may differ.
  • Not picked: DREO heaters whose Amazon titles say ‘bathroom’ (B09YXJMH87, B09YXR6LT5). DREO’s official Atom One page has no bathroom or ALCI wording, and the two listings show the same rating count (likely pooled). A Reaks bathroom heater had only 85 ratings.
  • No bathroom-rated heater that met the listing rules was left out.
  • Listing: checked on Amazon.com on November 5, 2026, sold and shipped by Amazon.com, new, item model number CD08200. None of the heaters were tested hands-on.

Official values used

Item Value Source Checked
US residential average electricity price (EIA) EIA Electric Power Monthly Table 5.3: U.S. total residential average price 18.16 cents/kWh in August 2026 (latest month); 17.23 cents/kWh for full-year 2025. cents/kWh eia.gov 2026-11-05
GFCI required for bathroom receptacles (NEC 210.8(A)(1)) NEC 210.8(A)(1) lists bathrooms among locations where dwelling-unit receptacles need GFCI protection for personnel. iaeimagazine.org 2026-11-05
Lasko: standard heaters not for bathrooms Lasko recommends conventional space heaters not be used in wet or damp locations, including bathroom or laundry areas; it makes separate heaters designed for bathroom use. z3nlasko.zendesk.com 2026-11-05
Vornado: not intended for bathrooms Vornado heaters are not intended for use in bathrooms or similar wet environments. vornado.com 2026-11-05
Plug a space heater directly into a wall outlet (CPSC, NFPA) Plug electric space heaters directly into a wall outlet, never an extension cord or power strip. cpsc.gov 2026-11-05
Keep space heaters 3 feet from combustibles (CPSC, NFPA) Keep portable heaters at least 3 feet from drapes, furniture, bedding and other combustible materials. cpsc.gov 2026-11-05
Look for auto shut-off if tipped over (NFPA) NFPA: make sure the heater has an auto shut-off that turns it off if it tips over. content.nfpa.org 2026-11-05

Bathroom heater check: quick reference

The calculator in this article shows the result for your own settings. Settings can be set in the URL; each link below opens the calculator with those settings.

Settings Result Calculator
Yes, GFCI-protected, 15 Only use a heater made for bathroom use. 1,500 W for 15 minutes uses 0.375 kWh. Lasko recommends that its conventional space heaters not be used in wet or damp locations, including bathrooms. Vornado says its heaters aren’t intended for bathrooms. Plug a space heater straight into a wall outlet, never an extension cord or power strip. Keep it at least 3 feet from anything that can burn. NFPA also says to look for one that shuts off if it tips over. This guide couldn’t confirm a tip-over shutoff on the pick’s official product page, so check the manual before you buy Open with these settings
Yes, GFCI-protected, 10 Only use a heater made for bathroom use. 1,500 W for 10 minutes uses 0.25 kWh. Lasko recommends that its conventional space heaters not be used in wet or damp locations, including bathrooms. Vornado says its heaters aren’t intended for bathrooms. Plug a space heater straight into a wall outlet, never an extension cord or power strip. Keep it at least 3 feet from anything that can burn. NFPA also says to look for one that shuts off if it tips over. This guide couldn’t confirm a tip-over shutoff on the pick’s official product page, so check the manual before you buy Open with these settings
Yes, GFCI-protected, 30 Only use a heater made for bathroom use. 1,500 W for 30 minutes uses 0.75 kWh. Lasko recommends that its conventional space heaters not be used in wet or damp locations, including bathrooms. Vornado says its heaters aren’t intended for bathrooms. Plug a space heater straight into a wall outlet, never an extension cord or power strip. Keep it at least 3 feet from anything that can burn. NFPA also says to look for one that shuts off if it tips over. This guide couldn’t confirm a tip-over shutoff on the pick’s official product page, so check the manual before you buy Open with these settings
Not sure, or no, 15 Check the outlet is GFCI-protected first. 1,500 W for 15 minutes uses 0.375 kWh. Per IAEI’s explanation of the National Electrical Code, the code calls for GFCI protection on receptacles in home bathrooms. Only use a heater in a bathroom if its manual or the maker’s page says it’s made for bathroom use. If it doesn’t say so, don’t use it there. Plug a space heater straight into a wall outlet, never an extension cord or power strip. Keep it at least 3 feet from anything that can burn. NFPA also says to look for one that shuts off if it tips over Open with these settings